![]() ![]() ![]() Note: Load carry limit and accessory compatibility is reduced with load bars, Please also check the maximum roof load capacity of your vehicle. Includes all hardware, components and the installation guide needed to fit Load Bars on a vehicle. Made from stainless steel and a durable, weather resistant black powder-coated aluminum. The Load Bars and Gutter Mount Legs can be used in the future as components to build a complete Front Runner Roof Rack. The sliding nut t-slots allow for quick fitting and removal of accessories and equipment on both the top and bottom of the slats. Uses the same strong, corrosion free aluminum slats found in Front Runner Slimline II Racks. The Load Bars are mounted directly to the rain gutters using Gutter Mounted Legs. You may not have the need for a full roof rack and find that you can get by using a set of Front Runner load bars.Ĭan be used to mount a Front Runner Roof Top Tent or other accessories where a low profile and smaller footprint is preferred. This low profile, smaller footprint solution includes:-ġx 10mm Roof Load Bar Wind Deflector and fitting instructionsĪll the components necessary to mount the Front Runner Load Bars to a vehicle with gutters. Jimny JA12 / JA22 / JB32 / SJ80 (95-98)Ī set of Gutter Mounted Load Bars used to transport gear on the roof of your vehicle when there’s no need for a full Front Runner Roof Rack.If your Load Bar kit uses Foot Rails, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot Rails listed above to determine the height of the rack from the crown (highest point) of the roof of the vehicle. >If your Load Bar kit uses Legs, add the height of the Load Bar (22mm/ 7/8") to the height of the Legs listed above to determine the height of the rack from your vehicle's rain gutters. To determine the approximate height from your vehicle's roof to the top of your Load Bar Kit, add the height of the Load Bar (22mm/ 7/8") to the height of the Foot or Grab-On Foot Foot listed above. The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts. Made from stainless steel and durable, weather-resistant black powder coated aluminum. The Load Bars and mounting system can be used in the future as components to build a complete Front Runner Roof Rack. Uses the same strong, corrosion-free aluminum slats found in Front Runner Slimline II Racks. These Load Bars are mounted to the vehicle's roof via a set of supplied Tracks and Track Mounted Feet.Ĭan be used to mount a Front Runner Roof Top Tent or other accessories where a low profile and smaller footprint are preferred. You may not need a full roof rack and find that you can get one by using a set of Front Runner Load Bars. This low profile, smaller footprint solution includes 4 40mm Feet, 2 1165mm Load Bars, 2 1150mm Canopy Tracks and fitting instructions - all the components necessary to mount the Front Runner Load Bars to the vehicle. A set of Load Bars with Track Mounted Feet is used to transport gear on the roof of your vehicle when there's no need for a full Front Runner Roof Rack. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |